fbpx

If calibrating the motion sensor is failed on switch console, please doing the factory sensor calibration.

 

Step 1: Please make sure your controller stays at power-off status, then put it on flat surface.

 

Step 2: Press the ‘-’ ‘B’ ‘HOME’ 3 buttons simultaneously, the Group A indicators and Group B indicators will flash alternately.

(LED1&LED2/ LED3&LED4)

Step 3: Press the‘+’button and 4 LED indicators will flash alternately.

Step 4: After about 15 seconds, all indicators will turn off, which means the controller finish calibrating.

You may also like